The company has passed ISO9001:2015 certification, and has been recognized by many customers for its excellent quality.
The company has been committed to the development, optimization and improvement of manufacturing technology, and has obtained ten patent certificates.
The company has injection molding machines, CNC machining centers, precision CNC lathes, as well as gold-plated and silver-plated production lines.
The company continues to improve in order to ensure the interests of customers and fully meet customer product needs.
Founded in 2005, WinWay is a Hong Kong based enterprise, which is located in Changan Town, Dongguan City.
WinWay focuses on providing you with precision machining, precision tooling, etching lid, precision hardware, precision mechanical, metal injection, precision metal, CNC precision, Precision Plating, CNC parts, Optical Communication Parts and Precision Medical Parts, high-mix/small-volume and Low-mix/high-volume manufacturing services.
Gold is the ultimate precious metal for electrical contact plating. For that reason, the electrodeposition of gold is used extensively in electrical component applications such as electrical contacts, connector pins, switches, sensors, and many others for which repeated physical contact occurs. Gold-plated parts exhibit excellent wear resistance, high hardness, corrosion resistance, high conductivity, solder-ability and excellent performance at high temperatures. We offer not only 24-karat gold plating but a variety of gold plating that exhibits the following benefits:
Because the plating layer has a certain thickness, after the surface treatment of the part, it will inevitably cause the change of the size of the part. Generally, the dimensions and tolerances of the parts specified on the design drawings refer to the final dimensions and tolerances of the parts. If the parts do not have matching requirements, electroplating or electroless plating is still feasible on the final dimensions of the parts; if the parts have higher precision, The fit gap after assembly cannot accommodate the thickness of the plating layer and its deviation relatively, so plating on the final size of the part is detrimental to the assembly and working performance of the product. In order to solve the problem of size matching of parts with matching requirements after plating, it is necessary to negotiate with the design and process departments of the parts to determine the pre-plating process dimensions of the parts, and reserve the thickness of the plating layer and the size deviation of the plating in advance. It must be noted that it is not feasible to reserve the thickness of the plating layer and not reserve the thickness deviation that may occur during plating.
The hard anodic oxide film on the surface of aluminum and aluminum alloy has high hardness and excellent wear resistance. It is a common method to improve the wear resistance of aluminum parts. In order to improve the service life of The quality anodized film layer has a relatively large thickness. Therefore, after the aluminum parts are hard anodized, the final size of the parts will change significantly. This rule is usually followed, which is the increase in the final size of the parts, which is roughly equal to the film 1/2 of the layer thickness, as shown in the figure. This value is widely used to estimate the size change of aluminum parts after hard anodization.
Accurate Precision Plating will protect, repair, extend or enhance the life of metal components by increasing corrosion resistance, load bearing, electrical conductivity, solderability and added cosmetic appearance. Upon specifications and engineering needs metal plating can achieve many benefits to metal components.
Products plated by PPC are integral in some of the manufacturing world’s most complex assemblies. Our metal plating finishes are found in safety-critical devices, such as ABS modules, drive-by-wire controls, commercial and military aircraft, and implantable medical devices.
Masking tape is used for precision electroplating to cover the electroplated parts that are not electroplated.
Precision electroplating usually means that the original tolerance of the parts that need to be electroplated (oxidized) is small, generally within 0.01mm. On the premise of meeting the product functionality, after electroplating (oxidation), the size of the parts can still meet the original tolerance requirements .